|Search||FAQ||US Titles||UK Titles||Memories||VaporWare||Digest|
|Memories of VideoDisc - Who's Who in VideoDisc|
Edgar Denlinger researched the high-frequency capacitive pickup circuitry of the RCA VideoDisc system.
Edgar J. Denlinger received the BS degree in Engineering Science from Pennsylvania State University, University Park, in 1961 and the MS and PhD degrees in Electrical Engineering from the University of Pennsylvania, Philadelphia, in 1964 and 1969, respectively. From 1961 to 1963 he was in the RCA Graduate Study Program while working in the RCA Applied Research Department, Camden, NJ. Until 1965, he was engaged in research on solid-state traveling-wave masers, superconducting magnets, and experimental transistors. From 1965 to 1967 he held a University of Pennsylvania Research Assistantship during which he did research on a bulk-effect oscillator. From 1967 to 1973 he was a Staff Member at Lincoln Laboratories, Massachusetts Institute of Technology, Lexington, working in the areas of microwave integrated circuits, phased-array antennas, and air traffic control. Since April 1973, he has been a Member of Technical Staff at RCA Laboratories, Princeton, NJ, engaged in research on millimeter-wave avalanche diodes, microwave integrated circuits, PIN and mixer diodes, low-noise receivers, and avalanche diode amplifiers. For his work on solid-state airborne weather radar, he received an RCA Laboratories Outstanding Achievement Award in 1979. He holds five patents. Dr. Denlinger is a member of IEEE, Sigma Xi, Tau Beta Pi, Sigma Tau, and Phi Kappa Phi. He is Chairman of the Princeton Chapter of the IEEE MTT/ED Group.
- RCA 1982 Company Biography
In 1985, Dr. Edgar J. Denlinger, Head, Signal Conversion Systems Research, RCA Laboratories was selected as an IEEE Fellow "for the studies of microstrip transmission line characteristics, and the development of microwave solid state devices and circuits."
Search for patents issued to Edgar Jacob Denlinger.
If you have some additional information to supply on Ed Denlinger, feel free to submit the form below, so your comments can be added to this page.
Send your comments in email via the Contact page