|
CED VideoDisc and Player Discussion Forum topics can be anything related to SelectaVision CED's, and could include offers to buy/sell/trade, repair advice, historical anecdotes, caches of CED's you've discovered, etc.
Click on the Register link to join.
|
View previous topic :: View next topic |
Author |
Message |
lyokian159
Joined: 01 Mar 2019 Posts: 1 Location: Long Island, NY
|
Posted: Fri Mar 01, 2019 9:40 am Post subject: SFT100 "Grinding" noise when playing |
|
|
Hi All,
New to the forums, I have had a SFT100 for a few years and its got a bit of an issue.
When spinning a disk I hear a repeated ticking/dragging noise, It subsides if I move the lever slightly out of the play indent.
I am assuming this is an issue with the turntable height but I cant find much info about adjusting this on this model player.
I have a fairly new Stylus from CEDatum and overall the player works well once I find the sweet spot to keep the lever in.
The player turns off and on normally in the off and load positions. If anyone has any thoughts I'd love to hear!
Thanks! |
|
Back to top |
|
|
jsdspif
Joined: 16 Jan 2016 Posts: 278
|
Posted: Sat Mar 02, 2019 1:03 pm Post subject: |
|
|
get a service manual for any player with a belt drive turntable,sgt200 or sgt250 or sears player are ones that come to mind or maybe there are sft service manuals but you access the adjustment by inserting an allen wrench down into the turntable shaft. Also at that time it would be good to remove the turntable to clean and lube the shaft and the "bearings" that the shaft rides in. The toughest part is the 2 screws that need to be removed from the turntable don't always want to come loose and the heads end up getting "stripped". So start with a screwdriver that fits the screw head perfectly and has no wear. If they don't want to come loose try tightening ever so slightly. I've head a number of times with screw and/or bolts not coming loose where attempting to tighten them a little bit more has caused them to "break" free,and then I could remove them. |
|
Back to top |
|
|
bdstearns13
Joined: 01 Jul 2021 Posts: 2 Location: Lexington,MA
|
Posted: Sat Jul 24, 2021 12:05 pm Post subject: |
|
|
So once you inset Allen key into the shaft, do you turn counter clockwise to adjust or just push down. Manual very vague. |
|
Back to top |
|
|
SelectaVision420
Joined: 25 Mar 2012 Posts: 1424 Location: Hartford
|
Posted: Sun Jul 25, 2021 2:32 am Post subject: |
|
|
clockwise to raise table. i only recommend 1/4-1/2 turn at a time between checks _________________ (2)Sears 274 & 934(80150,10&11350), sft100, sgt250, sjt 090-400, vp550, VDR3000, VP2000 & 4000
complete '84 Dimensia Owner |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|